Muhammad.com collection in 109 languages

  • COWS-fed-barely-sprouting-fodders, page : 91

Most heifers only need a minimal amount of assistance and calf pullers are only used if required. If you do need to pull, then the strength of one or two people is adequate.

If you need to pull a calf, remember he has to come in an arc, up over the cow's pelvis. When his feet are coming out through the vulva and you start to pull him, pull straight out. But, after you get his head, shoulders and ribcage you, you should pull downward toward the cow's hocks, which is the large joint halfway up the hind leg. If you watch normal, unassisted births, you will see how the calf curves around toward the cow's hocks and feet as he slides out. This same action is what you need to duplicate when pulling a calf for easiest delivery.

The less you use a calf-puller, the better. But sometimes a puller makes the difference or whether or not the calf is born alive, especially when time is a critical factor, as with a backward calf (hind feet first). It is wise to buy a good calf-puller and don't forget to keep it handy – it may hang there for years without being needed, but it will be there in an emergency. Don't forget to learn how to use it properly, otherwise the calves you deliver can have broken leg bones fractured by improper use of a calf puller.

How to use a calf-puller:
First: Position the puller correctly with the breech spanner against the cows' hindquarters below the vulva and the holding loop over backbone to keep it in place. Put chains on the calf's legs properly. A single loop above the fetlock joint may be adequate when pulling by hand, but it is never adequate when using a calf puller because of the risk of fracturing a leg. When using a calf puller, put a double loop on each leg. The first loop should go above the fetlock joint with a half-hitch round the calf's pastern (hoof).

Second: Take a few seconds to make a double loop – this can save weeks of recuperation for the calf. A single loop may pull at an awkward angel or put too much stress on one spot, causing joint or fractured bones. Double looping puts a straight pull on the leg and less chance for a break. Direction of pull should be from the bottom, pulling from the top may put twisting stress on the leg.

Third: Put chain ends on each leg separately. Tie a knot in the portion between the legs, at proper space for attaching the hook for the puller's cable. Take the slack out of the cable with the ratchet and begin to pull the calf.

Fourth: After the chains are properly on the calf's legs, shorten the puller or extend its cable as much as possible for maximum leeway for pulling. This is especially important if the calf is coming backward.